中频电炉,中频电源,中频设备和配件及维修
中频电源,中频电炉,感应加热设备,电炉维修专业厂家-保定兴盛中频设备有限公司
河北保定兴盛中频设备有限公司
电话:0312-7966818
传真:0312-7968665
手机:13503128018
邮箱:bdxsd@163.com
联系人:高先生
地址:保定清苑工业区金线河堤南,保清公路保沧高速桥北,兴盛路东行300米兴盛路9号
维护中频炉首先要做到
[来源:www.zhongpinshebei.com] [作者:aywl] [日期:17-04-07]

1.维护中频炉首先要做到一个星期或半个月停机检查机器所有性能,以便及时了解设备的情况,以下为每天必须做的以及一星期或半月的检查步骤。 1. Maintenance of intermediate frequency furnace, first of all, stop the machine to do a week or half a month to check all performance of machine, in order to understand the equipment in time, the following is a must do every day and check the steps of a week or half month. 2.为了机器在工作的时候更好的被使用,每天必须: 2. In order to machine better be used at work, every day must: (1)使用测温枪观察可控硅以及阻容保护电阻的温度和均压电阻的工作温度。其中测温时间分为3个阶段:第一次测温为机器运行第一炉钢水的时候大约开三分之一的功率后约5到10分钟后测温。第二次是大约这炉钢水快满的时候再测一次。然后就第三次在熔炼结束的时候也就是今天的最后一炉满功率的情况下测温。当然以上的3次测温都需要记录以便及时的发现问题和解决问题。 (2)每天检查电缆的螺丝有无松动现像。 (1) the use of temperature measuring gun observation of SCR and resistance capacity to protect the temperature of the resistance and compressive resistance of the working temperature. Including temperature measuring time is divided into three stages: the first time of molten steel temperature measuring for machine run first furnace when about a third of the open power after about 5 to 10 minutes after the temperature measurement. The second is about the furnace steel measure fast full again. Then the third time at the end of the melting today is the last of the furnace under the condition of full power measurement. Of course all three temperature measurement of the above need to record so as to find and solve problems timely. (2) check whether there is any looseness on the screws of the cable is like a day. (3)每天开机之前必须确认电源水泵以及炉体水泵的开启,水压为电源柜内1.5到1.7公斤压力,炉体1.5到2公斤压力。 (3) every day you must confirm the power supply before starting the pump and open furnace water pump, hydraulic pressure as power contained in 1.5 to 1.7 kg pressure, furnace pressure 1.5 to 2 kg. (4)炉体水电缆附近保持干净无铁屑以及金属物体。 (4) furnace water clean without iron and metal objects near the cable. 3.运行设备之前必须提前开水泵10分钟,以便观察有无漏水以及渗水情况如有发现立刻处理,以免造成影响生产。 3. Run the equipment before must open the pump for 10 minutes ahead of schedule, in order to observe any leakage and water penetration conditions such as have found immediately deal with, so as not to affect production. 4.机器如果在检测到可控硅温度异常应该立刻检查原因,看看是否水管折了起来引起水流量不够而发热,或者是可控硅管套里面有污垢堵塞现象。 4. If the machine is detected SCR temperature anomaly should immediately check the reason, see if gives out heat pipes to fold up cause flow is not enough, or is silicon controlled rectifier tube set there was dirt blocking phenomenon. 5.如果发现整流的阻容保护的电阻温度明显和其他电阻不一样应该立刻检查原因是否电容开路或者电阻已经损坏等等。一般会使电抗器明显的有开机时嗡嗡声感觉有点抖动现象。 5. If it is found that resistance capacity to protect the resistance of the temperature of the rectifier and other resistance should immediately check whether reason capacitance resistance or open, and so on have been damaged. Tend to make the reactor obviously has buzzing feeling a bit dithering phenomenon when the phone is switched on.

版权所有 © 河北保定兴盛中频设备有限公司  兴盛中频电炉设备主营:中频电炉,中频电源,中频设备,熔炼炉,感应加热电炉及配件与维修等
地址:保定清苑工业区金线河堤南,保清公路保沧高速桥北,兴盛路东行300米兴盛路9号 手机:13503128018 电话:0312-7966818 联系人:高先生 网址:www.zhongpindianlu.com.cn
友链:玻璃钢管 蠕动泵 护坡砖模具

保定网站建设及优化保定遨游网络公司